Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterAir Duct Cleaning in Frisco, TX
Whole-system HVAC cleaning in Frisco typically runs $350-$650 for a standard two-story home, with most jobs completed in one visit. Frisco’s housing stock, built almost entirely between 2000 and 2018, carries construction debris that never cleared out, and the Cross Timbers pollen load pushes filters past their limits every spring. We dispatch crews from our Dallas-Fort Worth office to serve Frisco directly, and every job starts with a written price before any panel comes off. Call (940) 240-8552 for a free estimate.
Why Frisco Homes Are Different
Frisco was one of the fastest-growing cities in the US through the 2000s and 2010s, meaning the vast majority of its housing stock is now 10-20 years old - built quickly during successive tract-home booms and never duct-cleaned since original construction. Those systems still carry drywall dust, blown insulation fragments, and debris from the original build, and homeowners are now hitting the age window where a first-ever cleaning is overdue across entire subdivisions simultaneously.
The large two-story builder homes in Phillips Creek Ranch, Starwood, and Westfalls Village commonly run 2,500-5,000 square feet with multi-zone HVAC, long duct runs, and flex duct installed under production pressure. More joints, more sags, more debris traps than custom work. Frisco’s position on the Blackland Prairie also means seasonal clay soil shift stresses slab foundations, and we’ve found flex-duct separations at registers that the homeowner never knew existed until the camera went in.
Summer heat drives systems nearly continuously from May through September, compressing filter cycles. Cedar elm, oak, and mountain cedar pollen infiltrates return systems and coats duct interiors. The combination - tight new construction, heavy pollen, long run times - produces particulate loads we don’t see at this concentration in older, leakier housing stock.
Our Main Frisco Services
Frisco homeowners call us most often for these three services. Each has its own page with full pricing and scope details.
Air Duct Cleaning in Frisco
Whole-system negative-pressure extraction for the supply and return ductwork, registers, and main trunk lines. In Frisco, we regularly pull construction-era drywall compound and cellulose fragments from systems that have never been cleaned since the original build. Every run is photographed before and after. Air Duct Cleaning in Frisco
Dryer Vent Cleaning in Frisco
Full vent run cleaning from appliance to exterior termination, with airflow testing before and after. Two-story Frisco homes with long vertical runs through attic space are especially prone to lint accumulation that reduces drying efficiency and creates fire risk. We document the restriction level in writing. Dryer Vent Cleaning in Frisco
Duct Repair & Sealing in Frisco
Flex-duct replacement, joint sealing with mastic, and register reconnection. Blackland Prairie soil movement separates connections we find in homes throughout the master-planned communities east of the Dallas North Tollway. We photograph every separation and deliver a written repair scope with fixed pricing. Duct Repair & Sealing in Frisco
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterHVAC Cleaning in Frisco
HVAC cleaning in Frisco addresses the particulate buildup that accumulates in components the homeowner never sees. The same construction debris and pollen loading that fills ductwork also coats evaporator coils and blower assemblies, reducing heat transfer and forcing longer run times during our May-to-September cooling season. We clean the full mechanical system, not just the ducts, and every component is photographed before and after. Our HVAC Cleaning service hub has additional technical detail on equipment and methods.
Evaporator Coil Cleaning
Signs you need it
Ice formation on the coil, reduced airflow at registers, or cooling that can’t keep up on 100-degree Frisco afternoons.
What it costs in Frisco
Evaporator coil cleaning typically runs $180-$320 as a standalone service, or $120-$200 when bundled with full system cleaning.
How we do it
We remove the access panel, apply foaming cleaner to the coil fins, rinse with low-pressure water to avoid fin damage, and photograph the before and after condition for the job record.
Blower Cleaning
Signs you need it
Vibration or noise from the air handler, uneven airflow between rooms, or dust puffing from registers when the system cycles on.
What it costs in Frisco
Blower assembly cleaning ranges from $150-$280, depending on whether the motor requires removal for full access.
How we do it
We disconnect power, remove the blower assembly, clean the wheel and housing with compressed air and solvent, balance the wheel, and reinstall with torque to manufacturer spec.
What HVAC Cleaning Costs in Frisco
| Item | Typical range in Frisco |
|---|---|
| Evaporator coil cleaning (standalone) | $180-$320 |
| Blower assembly cleaning | $150-$280 |
| Full HVAC system cleaning (coil + blower + ducts) | $450-$750 |
How do I know my HVAC components are actually dirty?
We show you. Every HVAC cleaning includes a Documented Photo Record of the coil, blower, and duct interiors before any work begins, so you see the debris buildup yourself before approving the scope.
Can HVAC cleaning reduce my summer electric bill in Frisco?
Yes. A coated evaporator coil or clogged blower forces longer run times; clean components transfer heat properly and cycle less. Most Frisco homeowners see reduced runtime during peak months.
Air Quality & Sanitizing in Frisco
Air quality treatment in Frisco targets the microbial growth that thrives in ducts loaded with construction dust and pollen residue, especially during humid spring and fall transitions when systems cycle less and condensation sits in the plenum. The same tight, energy-efficient homes that keep conditioned air in also trap moisture and particulate, creating conditions for bacteria and mold in components that never dry fully. We treat the source, not the symptom, and document every step. Our Air Quality & Sanitizing service hub details the full equipment roster and treatment protocols.
Mold Treatment
Signs you need it
Musty odor when the system runs, visible growth on register fins, or allergy symptoms that worsen at home and improve away from the house.
What it costs in Frisco
Whole-system mold treatment runs $400-$700 depending on contamination extent and whether physical removal is required before chemical application.
How we do it
We apply an EPA-registered antimicrobial through the duct system using a fogging applicator, with dwell time per manufacturer specification, then verify treatment coverage with post-application photography.
UV Light Installation
Signs you need it
Recurring microbial growth after cleaning, chronic musty odor, or household members with mold sensitivity or respiratory conditions.
What it costs in Frisco
UV-C light installation at the coil or plenum typically costs $280-$450 including the lamp, ballast, and wiring to code.
How we do it
We mount a Honeywell or Aprilaire UV lamp upstream of the coil, wire to the air handler’s 24-volt circuit, and set the lamp replacement reminder for the 12-month service interval.
What Air Quality & Sanitizing Costs in Frisco
| Item | Typical range in Frisco |
|---|---|
| Mold treatment (whole system) | $400-$700 |
| UV light installation | $280-$450 |
| Bacteria sanitizing (standalone) | $200-$350 |
Is mold treatment safe for kids and pets?
Yes. We use EPA-registered antimicrobials formulated for HVAC application, with specified dwell and ventilation times; the system is safe to operate normally after the treatment period.
How long does UV light take to work?
UV-C begins reducing microbial growth immediately, but full odor reduction typically takes 2-4 weeks of continuous operation as the existing biofilm breaks down.
Brands We Service in Frisco
We stock parts and service equipment from Honeywell, Aprilaire, Rotobrush, and Nikro, with most common filters, UV lamps, and cleaning attachments available on the truck. If we don’t have it, we source from Dallas-Fort Worth supply houses with next-day turnaround. See our brands for the full equipment roster.
Pricing for Air Duct Cleaning in Frisco, TX
| Service | Typical range in Frisco |
|---|---|
| Whole-system air duct cleaning (standard home) | $350-$650 |
| Whole-system air duct cleaning (large home, 4,000+ sq ft) | $550-$900 |
| Dryer vent cleaning | $120-$220 |
| Duct repair & sealing (per run) | $150-$350 |
| Evaporator coil cleaning | $180-$320 |
| Blower assembly cleaning | $150-$280 |
| Full HVAC system cleaning | $450-$750 |
| Mold treatment | $400-$700 |
| UV light installation | $280-$450 |
| Bacteria sanitizing | $200-$350 |
Price drivers in Frisco include home size (many systems serve 3,000+ square feet), number of air handlers in multi-zone setups, and accessibility of attic or crawl-space ductwork. Every price is written and agreed before work starts, per Haven Standard Clause 1. No per-vent pricing, no add-ons after arrival.
Neighborhoods We Serve in Frisco
We work throughout Frisco’s master-planned communities, with crews dispatched from our Dallas-Fort Worth office for scheduled appointments. Most Frisco homeowners receive a same-week slot.
- Phillips Creek Ranch
- Starwood
- Westfalls Village
- Grayhawk
- Stonebriar
Service Area - Cities Near Frisco
Our crews serve the full Dallas-Fort Worth metro from our regional office, with regular appointments in Little Elm, TX, Denton, TX, Lewisville, TX, and McKinney, TX. Scheduling is coordinated centrally; your technician is identified by name before arrival.
Serving Frisco, TX - Our Local Coverage Area
We’re based in the Frisco area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Air Duct Cleaning in Frisco
Most Frisco master-planned communities have no pre-approval requirement for interior maintenance, but gated neighborhoods may need a vendor pass for the service vehicle. We handle gate code coordination when you schedule; our technicians carry identification and Haven Standard Clause 3 verification.
We typically hold appointments within 3-5 business days for standard cleaning, with priority scheduling available for documented airflow or mold concerns. All calls are answered by a live person who can check real-time availability.
Yes. We work throughout Frisco, including the large subdivisions east of the tollway where mid-2000s construction debris is most commonly found in original ductwork. Crews are dispatched from our Dallas-Fort Worth office with GPS routing for on-time arrival.
What happens when you call
- 1A real person answersNo phone trees - talk to a local air duct cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Frisco Customers Say
"The before and after photographs of each run are the reason I used them. You cannot argue with what came out of the return."
- Marguerite O."Thorough job on the ducts and the dryer vent. Left the house clean and the paperwork was clear."
- Rafael I."They found a disconnected duct in the crawl space that had been dumping conditioned air under the house for years. Photographed it, quoted the repair, fixed it."
- Devon A.